HVAC & Plumbing Services in Kansas City, MO

Completed installation of new three-handle tub/shower valve and trim kit in commercial setting. Accessed valve location through closet opening with two-person crew. Cut drywall above existing tile wall to install new shower drop ear 90 with PEX adapter, allowing vertical PEX routing to preserve tile integrity. Installed backing for showerhead drop ear 90 with additional drywall removal as needed due to age of existing tile. Completed valve and trim installation with two isolation shut-off valves for future serviceability.

Responded to no cooling complaint on 10+ year old outdoor unit. Upon arrival, confirmed outdoor fan motor operating but system not producing cool air. Performed diagnostic temperature measurements, recording 81.8°F at return air filter and 66.9°F at equipment. Identified cooling system failure preventing proper refrigeration cycle operation.

Conducted on-site assessment of 20-year-old gas water heater to provide replacement estimate. Inspected existing unit, which is currently operational but has reached end of expected service life. Documented water heater specifications including 150 PSI maximum working pressure rating, gas control assembly with temperature and pilot control system, and connection points. Evaluated supply and discharge piping configuration, including insulated hot and cold water lines with brass fittings and shutoff valves. Photographed existing installation to document current setup and facilitate accurate replacement planning for new water heater installation.

Installed customer-supplied shower valve rough-in assembly and reconstructed the shower P-trap system, replacing both 2-inch and 1½-inch drain piping to ensure proper drainage and code compliance. The installation included mounting the valve body, connecting supply lines, and verifying all connections for leaks prior to wall closure, with trim installation to be completed at a later date.

Completed on-site estimate for washer and dryer installation requiring new water supply and drain connections. Assessed existing plumbing infrastructure in utility area, including water heater location and available access points for hot and cold water lines. Evaluated drainage requirements and determined routing for new supply lines and waste connection to accommodate laundry appliances where none currently exist.

Responded to a toilet flush valve leak where water level continued to rise after initial adjustment. Inspected toilet tank components and identified faulty fill valve assembly causing continuous water flow. Replaced the fill valve mechanism with new unit, adjusted water level to proper height below overflow tube, tested flush cycles for proper operation, and verified complete seal with no residual leaking. Checked supply line connection at angle stop valve for any signs of deterioration or leakage. All components now functioning properly with stable water level maintained in tank.

Responded to service call for multiple faucet issues throughout the property. Replaced cartridges in two wall-mounted two-handle bathroom faucets after coordinating building water shutoff and using penetrating lubricant to remove seized components. Addressed dripping kitchen faucet and applied fresh silicone caulk to deteriorated areas in kitchen and bathroom sink installations to prevent water intrusion and ensure proper sealing.

Responded to service call for multiple plumbing fixtures requiring attention. Installed new sink in kitchen as requested. Addressed running toilet issue in general bathroom by inspecting and servicing the flush valve assembly and flapper mechanism, which showed signs of wear and mineral buildup. Completed toilet installation in master bathroom, ensuring proper seal and water supply connection. All fixtures tested for proper operation and leak-free performance upon completion.

Responded to service call for leaking water heater. Upon arrival, inspected 9-year-old tanked water heater unit and confirmed active leak condition. Visual assessment revealed significant corrosion and oxidation on copper supply piping and connections at top of tank, with green and brown patina indicating advanced deterioration. Blue plastic fitting showed signs of age-related wear. Tank exterior displayed accumulated debris and dust consistent with unit age. Documented existing conditions with photographs showing corroded inlet piping and overall tank condition. Discussed findings and replacement options with customer given age of unit and extent of corrosion damage to plumbing connections.

Responded to reported low water pressure throughout home occurring when toilets were flushed, along with slow drainage in master bathtub. Conducted comprehensive inspection of plumbing system including crawl space and attic areas to identify source of pressure loss. Located and examined main water supply lines, including copper piping with shut-off valves. Inspected visible plumbing infrastructure for obstructions, leaks, or valve restrictions that could impact water flow. Documented existing conditions of copper supply lines showing normal aging and patina. Assessed HVAC ductwork proximity to plumbing components to rule out any interference issues. Identified potential causes of pressure fluctuations and drainage concerns requiring further evaluation and repairs.

Conducted on-site evaluation of 25+ year old gas water heater in basement showing signs of active failure. Assessed existing 50-gallon gas unit, documented corroded copper supply lines with significant green patina oxidation, and evaluated surrounding plumbing infrastructure including condition of pipe connections and fittings. Provided detailed estimate for replacement of aging water heater system with new 50-gallon gas unit, including necessary updates to deteriorated supply piping and proper venting requirements.

Responded to report of water leak in garage ceiling that occurred when water was used inside the home. Upon arrival, accessed the area above the garage ceiling to investigate the source of the leak. Inspection revealed compromised plumbing line or connection within the floor joist cavity above the affected area. Documented existing conditions including disturbed insulation and structural access points near HVAC ductwork. Identified active leak source requiring repair of water supply line. Provided estimate for necessary repair work to resolve the leak issue and prevent further water damage to the ceiling below.

Responded to reported water leak in kitchen and bathroom areas. Upon inspection, identified leaking supply line connection at wall-mounted fixture showing visible rust staining and moisture damage on surrounding white surface. Tightened threaded metallic fitting and secured flexible supply hose with hose clamp to eliminate leak at connection point. Inspected under-sink plumbing infrastructure in cabinet, examining PVC drain trap assembly, multiple pipe joints, and supply line connections. Verified all connections were properly secured and leak-free. System tested and confirmed operational with no active leaks present at time of service completion.

Responded to reported water leak in garage ceiling. Upon inspection, identified source of leak in plumbing system above garage area. Accessed affected piping through ceiling access point, located compromised PVC pipe connection with visible moisture damage to surrounding materials. Repaired leaking joint, secured all connections, and verified system integrity through pressure testing. Cleanup completed and area restored.

Performed sewer line camera inspection to assess underground drainage system condition. Accessed utility space containing plumbing infrastructure and deployed video inspection equipment through accessible cleanout points. Successfully captured visual documentation of interior pipe conditions to identify any blockages, damage, or areas requiring attention.

Responded to service call for gas line inspection at fireplace and multiple water leaks in bathroom and utility closet. Inspected gas line to fireplace and capped off as needed per customer request in preparation for home sale. Addressed water supply valve leak in bathroom, which showed signs of corrosion and deterioration on the shut-off valve assembly and copper supply line connections. Repaired or replaced corroded valve components exhibiting green patina and mineral buildup at threaded connections. Investigated water leak in utility closet adjacent to water heater and performed necessary repairs to eliminate active leaks. Documented all findings and repairs with photos for service records.

Responded to call for basement drain backup near water heater and furnace area with recurring flooding issues. Upon arrival, observed third-floor toilet causing gurgling sounds in plumbing system and triggering basement floor drain overflow when flushed. Performed main line cleanout to clear obstruction in primary drainage system. Removed blockage causing air trap conditions and restoring proper venting throughout vertical plumbing stack. Tested system by flushing third-floor toilet multiple times and verified basement drain no longer backing up. Confirmed proper drainage flow and elimination of gurgling sounds in fixtures.

Performed routine maintenance flush on electric tankless water heater located in basement for new preventive maintenance agreement member. Successfully completed descaling procedure using appropriate chemicals to remove mineral buildup and maintain optimal unit performance. Verified system pressure and operational functionality upon completion.

Responded to main drain stoppage in basement of 55-year-old home caused by tree root intrusion. Successfully cleared main drain line using professional drain cleaning equipment to restore proper flow and drainage. Additionally replaced deteriorated wax ring seal on toilet as requested to prevent future leaks and ensure proper fixture operation.

Responded to reported water heater leak in basement. Upon inspection, identified minor leakage at tank connections requiring approximately two towels to contain moisture. Assessed plumbing configuration including hot and cold water supply lines with appropriate color-coded piping, brass fittings, and venting system. Tightened connections at water heater tank interface and verified proper installation of expansion tank and associated valves. Tested system for additional leaks, confirmed proper operation, and ensured all connections were secure to prevent future water discharge.